Philips Respironics Innospire Go Portable Mesh Nebulizer

InnoSpire Go features Aerogen's Vibronic mesh technology used in hospitals worldwide. The mesh vibrates, drawing the medicine through approximately 1,000 precision-formed microscopic holes, creating a fine aerosol mist. Medication reaches deep into your lungs where it's most needed and most effective.

The rechargeable battery provides up to 30 treatments (120 minutes of use) between each charge.

InnoSpire Go is intended to nebulise commonly prescribed liquid inhaled medications for respiratory disease. Typically these are bronchodilators, steroids and antibiotics.

InnoSpire Go has been tested and is compliant to the DO-160F standard to show it meets safety standards to use on an airplane. However, each individual airline will have their own policies with regards to the use of electronic equipment and you should therefore check with the airline prior to travel if you need to use your equipment during a flight.

InnoSpire Go has been tested and is compliant to the DO-160F standard to show it meets safety standards to use on an airplane. However, each individual airline will have their own policies with regards to the use of electronic equipment and you should therefore check with the airline prior to travel if you need to use your equipment during a flight.

It should take approximately four minutes for 2.5 ml salbutamol. Other medications may take longer, but typically most will nebulize in under five minutes.

The maximum fill level is 8 ml indicated by the word MAX under the lid hinge.

Your treatment is finished when the device beeps and the light ring flashes, InnoSpire Go will turn off automatically.

The first time you charge the battery will take up to three hours and all further charges will take less than two hours to fully charge.

Yes. The InnoSpire Go nebulizer is BPA free.